Also, the input and output sensitivity can each be switched, so the input can accept line or guitar level, and the output can send at amp or line level — which means that they can be used for most applications on stage or in the studio. Each pedal takes up little space x x 54mm and weights only 1kg. This is located on the rear panel alongside the USB connector for software updates , jacks for an optional expression pedal and Aux switch, plus the two input and two output jacks. Up to 40 user programs can be stored, and you can change instantly between programs without any glitches or gaps. The footswitches can be used in two modes. The patches are organised in 20 banks of two, but you can also hide unused banks, so that only those you want to access are displayed.
|Published (Last):||14 September 2012|
|PDF File Size:||2.53 Mb|
|ePub File Size:||20.52 Mb|
|Price:||Free* [*Free Regsitration Required]|
This globally can be enabled either , meaning it is active all the time, or on a preset by preset basis. When Killdry is enabled, ModFactor does not send any dry signal to the outputs; only the Effect. Note that when Killdry is enabled, Bypassing will mute the Effect rather than Bypass it. For example, there are several types of Flangers, Phasers, etc. For each of the ten modulation Effects, use Type to select. Page Flanger Q, while Depth controls the frequency offset of the left and right channels to create a stereo image.
Rotary Simulates the sound of a rotating speaker for that popular Leslie effect. TremoloPan Tremolo is an effect that is created by modulating the level of the incoming audio with an LFO. Page Intensity For TremoloPan type Opto, Intensity controls input slew rate Edge and, depending on the input signal, may only have a subtle effect.
Type Selects the type of effect. Page Catchup 5. Page Expression Pedal Expression Pedal should be a simple resistive potentiometer with a maximum value of between 5k Ohms and 20k Ohms. Refer to www. Brake mode slows the LFOs at a constant rate while the switch is pressed.
When the switch is released, Brake the LFOs return to their previous rate. Expression pedal mapping. While Tempo values are always saved with the Preset, you may prefer to have your current Tempo stay the same as you switch from Preset to Preset. Page Saving Presets Preset will not be saved. This is intentional. When you save a new Preset, you overwrite the old Preset. ModFactor is designed to assure that saving is a deliberate act.
The Preset number corresponding to the currently running Preset will flash as a warning that saving in this location will overwrite the currently loaded Preset. As noted above, the ModFactor has two operating modes, Bank and Play.
Alternately, some users may want to have all six switch functions immediately available 3 from each Footswitch Mode. For more advanced users, it offers a number of extra routing modes, which control the functions of the inputs and outputs.
One output will be dry, meaning that the output is the same as the input or mix if two inputs are used , whereas the other will be wet, using a mono output version of the effect.
Eventide ModFactor Manuals & User Guides
Eventide MODFACTOR Quick Reference Manual
Eventide ModFactor User Manual
ModFactor User Guide