ASTM D3295 PDF

More D Five groups of PTFE tubing, miniature beading and spiral cut tubing, differentiated by size and type are presented. The groups are further subdivided into classes based on wall thickness: group 01 - tubing based upon the AWG sizes, group 02 - tubing based upon fractional inch sizes, group 03 - tubing based upon inner diameter and wall thickness, group 04 - tubing cut to form spiral wrap, and group 05 - miniature beading. The types are further differentiated in accordance with increasing wall thickness as follows: class 1 - light wall, class 2 - thin wall, class 3 - standard wall, class 4 - chemical tubing, and class 5 - heavy wall.

Author:Kigasho Kazizuru
Country:Belarus
Language:English (Spanish)
Genre:Relationship
Published (Last):28 October 2014
Pages:93
PDF File Size:12.46 Mb
ePub File Size:2.68 Mb
ISBN:922-1-73537-252-2
Downloads:16987
Price:Free* [*Free Regsitration Required]
Uploader:Faern



A number in parentheses indicates the year of last reapproval. This standard has been approved for use by agencies of the U. Department of Defense. The inch-pound units given in parentheses are forinformation only.

It is the responsibility of the user of thisstandard to establish appropriate safety and health practicesand determine the applicability of regulatory limitations priorto use. However, markets do exist fornon-virgin PTFE as additives and fillers. Referenced Documents2.

The groups are further subdivided into classesbased on wall thickness. Current edition approved Sept. Published September Originallyapproved in Last previous edition approved in as D - 06 DOI: United States The system uses predefined cellsto refer to specific aspects of this specification, as illustratedbelow.

These shall bebased on AWG size within the group and class. Grade will bethe AWG size designation. Only Groups 01 and 02 shall haverequirements for Class and no separator is needed. Physical Properties5. The tubing shall exhibit nosignificant change in color after heat-aging in accordance with8.

LIBERHAN COMMISSION REPORT PDF

ASTM D3295

A number in parentheses indicates the year of last reapproval. This standard has been approved for use by agencies of the U. Department of Defense. The inch-pound units given in parentheses are forinformation only. It is the responsibility of the user of thisstandard to establish appropriate safety and health practicesand determine the applicability of regulatory limitations priorto use.

DS1489 DATASHEET PDF

ASTM D3295 PDF

.

HITLERS WILLIGE VOLLSTRECKER PDF

LOCTITE® Military Specification Product Listing

.

Related Articles