ASTM C645 PDF

Specifying non-structural steel studs for interior walls May 1, There are two thicknesses of gauge products. This table shows the difference between the non-structural and structural products. For non-structural steel studs, there is no requirement for elongation i. Typically, the base metal thickness of non-structural members will range between 0. However, thicknesses greater than 30 mil are typically considered to be structural members. For example, gauge interior wall partition studs have a thickness of 0.

Author:Kasho Gurisar
Country:New Zealand
Language:English (Spanish)
Genre:Politics
Published (Last):2 March 2008
Pages:459
PDF File Size:18.32 Mb
ePub File Size:14.62 Mb
ISBN:560-5-60515-316-1
Downloads:39127
Price:Free* [*Free Regsitration Required]
Uploader:Kijind



More C Members shall be manufactured from steel and shall have a protective coating. Studs and rigid furring channels shall have a configuration and steel thickness such that the system in which they are used will carry the design transverse loads without exceeding either the allowable stress of the steel or the allowable design deflection.

Members shall be manufactured in such a fashion as to minimize burrs and sharp edges. Penetration test shall be done for performance requirements, where members shall be capable of pulling the head of the screw below the surface of the gypsum board without spin out. Apparatus and materials shall satisfy the testing requirements of the specification. This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application.

ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. Scope 1. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

JAIVA KRISHI PDF

Specifying non-structural steel studs for interior walls

Members shall be manufactured from steel and shall have a protective coating. Studs and rigid furring channels shall have a configuration and steel thickness such that the system in which they are used will carry the design transverse loads without exceeding either the allowable stress of the steel or the allowable design deflection. Members shall be manufactured in such a fashion as to minimize burrs and sharp edges. Penetration test shall be done for performance requirements, where members shall be capable of pulling the head of the screw below the surface of the gypsum board without spin out.

DAS BILD ROSE MADDER PDF

.

KISARI MOHAN GANGULI ATA PDF

.

Related Articles